J**N
400mw vtx pinout is wrong. You will fry it!
The f765amp flight controler stack is an all around BEAST.I own two of these now and might just get a third. Works great on a 5inch quad as well as my 7inch 294mm long range.6s and 65amps is scary fast and the f7 has Smartport and FportOption as well. I can fly over 100mph or fly it 3km every day of the week. I admit I had to work with a factory technician to get it going on my first attempt because I was making a mistake. I had the esc upside down. And the wiring diagram for the 400mw vtx is wrong, dont use it. Contact HGLRC to get the correct pinout for the 400mw vtx and OSD or you will fry it. I did and they sent me a brand new one with proper pinout. Jason Patton
F**D
Doesn't work with JB FC it seems? Or I screwed up the cable, but it's going back.
It gets 2 stars because it's pretty, but I have spent way too many hours trying to get this to work with the Joshua Bardwell flight controller board. They don't have the same pinout for the cable (he uses airbot style) so you have to chop up the cable and reroute. I checked everything 1000 times it seems, and it all checks out. But the ESC shows up as 'Protocol Unknown' in BLHELI32 Configurator. And If I plug the battery in, it will power the fc, but then this ESC board power cycles over and over, making my motors play the startup sound endlessly and it gets out of sync. If I plug in the esc to the battery without the 6-pin cable attached it seems just fine.Any help would be greatly appreciated. I just ordered 4 discrete HGLRC escs, but I really wanted this 65amp beast to work. ;(
S**M
I'm going to try it one more time.
It will just stop working, for no reason. I had three of these esc and with the 1st I figured it was my fault. The second, I made sure to take extra precautions while soldering. Made sure the pinout was correctly wired and had a smoke stopper. It powers up 3 times with the di di di...di di tone, no problem. The fourth time just my flight controller, receiver and vtx lights up. I shake my head and comb over with my magnified goggles on. Not a speck of solder out of place. The third time fresh out the box brand new, I solder the xt60 and connect the flight controller up, give it power just flight controller lights up. (FC HGLRC's airbus f4 and the f7)
M**.
Popped and sizzled
The pinout isn't the same as a standard flight controller pinout. Or so you would think based on the label. So you go through all the trouble of making a custom connector for your flight controller? Nope! That V and G are G and V respectively. Just connected it up? Say goodbye to the ESCs AND your FC.Be careful. Check it with a multimeter.
C**S
Robust and RELIABLE
My favorite drone uses this stack. I've had NO problems with it. Responsive, durable and clear documentation. It was easy to set up and build with and it's been great to fly with
K**O
HGLRC is the Best!
Overall HGLRC is the favorite company making quadcopter FC & ESC's and their quality is amazing. The Zues35 is my all time favorite FC ever.
D**.
Well designed and decent setup
Well laid out solder pads and good build quality. Easy to set up and solid current rating for a 6S 4in1 setup.
S**K
Good build quaility
Looks to be of good quality. Havent put it in a build yet. Will update review later.
Trustpilot
1 month ago
1 month ago
